Descargar Imprimir esta página

Metrix GX-1030 Guia De Inicio Rapido página 23

Ocultar thumbs Ver también para GX-1030:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

REAR PANEL
The Rear Panel provides multiple interfaces, including Counter, 10 MHz In/Out, Aux In/Out, LAN, USB Device, Earth
Terminal and AC Supply Input.
Counter
BNC connector. The input impedance is 1 MΩ. This connector is used to accept the signal measured by the frequency
counter.
Aux In/Out
BNC connector. The function of this connector is determined by the current operating mode of the instrument.
Sweep/Burst trigger signal input port of external trigger.
Sweep/Burst trigger signal output port of internal/manual trigger.
Burst gating trigger input port.
Synchronization output port. When synchronization is enabled, the port can output a CMOS signal with the same
frequency as basic waveforms (except Noise and DC), arbitrary waveforms, and modulated waveforms (except
external modulation).
AM, DSB-AM, FM, PM, ASK, FSK, PSK and PWM external modulation signal input port.
10 MHz Clock Input/Output Port
BNC connector. The function of this connector is determined by the type of the clock source.
If the instrument is using its internal clock source, the connector outputs the 10 MHz clock signal generated by the
crystal oscillator inside the generator.
If the instrument is using an external clock source, the connector accepts an external 10 MHz clock source.
Earth Terminal
The Earth Terminal is used to ground the instrument. AC Power Supply Input.
AC Power Supply
The GX 1030 can accept two different types of AC input power. AC power: 100-240 V, 50/60 Hz ou 100-120 V, 400 Hz
Fuse: 1.25 A, 250 V.
USB Device
Used when connecting the instrument to an external computer to allow waveform editing i.e., EasyWaveX) and remote
control.
LAN Interface
Through this interface, the generator can be connected to a computer or network for remote control. An integrated
testing system may be built, as the generator conforms to the VXI-11 class standard of LAN-based instrument control.
Aux
Counter
In/Out
LAN interface
USB device
10 MHz Clock Input/Output
Earth terminal
AC power supply Input
23

Publicidad

loading