Metrix GX-1030 Guia De Inicio Rapido página 22

3) Basic Waveform Parameters Area
Shows the current waveform's parameters of each channel. Press Parameter and select the corresponding softkey to
highlight the parameter to configure. then use number keys or knob to change the parameter value.
4) Channel Parameters Area
Displays the load and output load, as selected by the user.
Load ---- Value of the output load, as selected by the user.
Press Utility → Output → Load, then use the softkeys, number keys or knob to change the parameter value; or continue
pressing the corresponding output key for two second to switch between High Impedance and 50 Ω.
High Impedance: display HiZ
Load: display impedance value (the default is 50 Ω and the range is 50 Ω to 100 kΩ).
Output: Channel output state.
After pressing corresponding channel output control port, the current channel can be turned on/off.
5) LAN Status icon
The GX 1030 will show different prompt messages based on the current network status.
This mark indicates LAN connection is successful.
This mark indicates there is no LAN connection or LAN connection is unsuccessful.
6) Mode Icon
This mark indicates current mode is Phase-locked.
This mark indicates current mode is Independent.
7) Menu
Shows the menu corresponding to the displayed function. For example, «User Interface» Figure, shows the parameters
of AM modulation.
8) Modulation Parameters Area
Shows the parameters of the current modulation function. After selecting the corresponding menu, use number keys
or knob to change the parameter value.
22