Publicidad
Idiomas disponibles
Idiomas disponibles
CHECKS AND MAINTENANCE
Checking the front brake pads for wear
REAR BRAKE
Checking the rear brake fluid level
92
The condition of the brake pads can be checked by
observing the end of the 2 pads on the caliper they
should have a minimum thickness of 2 mm.
In the case of a lower thickness, immediately replace
them.
Note:
Perform this check according to the schedule shown
on the chart at (p.102).
For replacement, contact a SHERCO authorized
service center.
The minimum brake fluid level should never be below
1
the [MIN] mark on the brake fluid reservoir.
To restore the level , fill the tank after having removed
its cap
If the brake pedal becomes too soft there could be an air bubble in
the system, if this is the case, immediately contact a SHERCO dealer.
Use the fluid indicated in
Lubricants and Fluids‰ table.
.
1
WARNING
NOTE
(p.70)
in the „Recommended
Publicidad
