Publicidad
Idiomas disponibles
Idiomas disponibles
CHECKS AND MAINTENANCE
SPARK PLUG
96
0,6 - 0,7 mm
1
Keeping the spark plug in good condition helps to
decrease fuel consumption and helps optimize the
engine performance.
For this check, simply remove the spark plug cap
and remove the spark plug using the provided tool.
Thoroughly clean the electrodes using a wire brush.
Blow the spark plug off with compressed air to avoid
the possibility of any residue penetrating the engine.
Check the spark plug gap.
The gap between the electrodes must be between
0.6 - 0.7 mm, in case this does not correspond to
this value it is necessary to gently correct the spacing
of electrodes.
Also check that the insulation is not cracked and that
the electrodes are not corroded. If this is the case
immediately replace the spark plug.
Lubricate the threads of the spark plug and ( with
the motor cold ), screw it by hand until it stops then
tighten it with the provided tool.
WARNING
Do not perform this check with the engine hot.
1
Publicidad
