Honda WMP20XE1T Manual Del Propietário página 6

APPROVED LIQUIDS
The following is a list of chemicals that the multi-purpose pump is
capable of pumping. The operator must verify that the liquid that is to
be pumped is on these lists. After each use, drain the pump chamber
into a suitable container and flush with fresh water.
DO NOT USE FOR PUMPING LIQUIDS FOR HUMAN
CONSUMPTION.
DO NOT USE FOR PUMPING FLAMMABLE LIQUIDS.
 WARNING
Chemicals can cause burns or serious injury.
Wear protective clothing and eye protection when handling
chemicals.
Follow the chemical manufacturer's handling procedures.
NOTICE
Pumping liquids that are not listed may cause damage to the pump.
Agricultural Chemicals
Aatrex Dual
Amiben Eradicane
Ammonium Extrazine
Thiosulfate
Banvel Larsban
Basagran Lasso
Bicep URAN Solutions
Bladex Modown
Industrial Chemicals
Acetic Acid, 20% Glycerine (Glycerol)
Aluminum Sulfate Lactic Acid
Ammonium Nitrate Lead Acetate
Ammonium Sulfate Magnesium Chloride Sodium Bisulfite
Barium Sulfate Magnesium Nitrate
Borax (Sodium Magnesium Sulfate
Borate)
* Calcium Chloride Maleic Acid
Citric Acid Nickel Chloride
Copper Sulfate Nickel Sulfate
Detergents Oleic Acid
(General)
Ethylene Glycol Phosphoric Acid,
0-80%
Fatty Acids Potassium
Carbonate
Ferric Nitrate Potassium Chloride
Ferric Sulfate Potassium Nitrate
Ferrous Sulfate Potassium Sulfate
6
Formaldehyde,
40%
* Temperature does not exceed 26°C.
The temperature operating range of the pump is between
-7 ~ 54°C.
PUMP PERFORMANCE
The maximum pump discharge capacity is determined when pumping
clear water at 0 meters total head and at sea level. As the total head
[1] (discharge head [2] + suction head [3]) increases, pump discharge
capacity decreases (see figure). If the pump is used at higher
elevations, pump discharge capacity may also decrease. Other
factors affecting pump discharge capacity are:
• The type of chemical being pumped.
• The length and type of the suction and discharge hose used.
N-Serve 24
Phosphoric Acid
Solutions
Poly-N
Ranger
Round-up
Sutan
Treflan
Vernam
Sodium Acetate
Sodium Bicarbonate
Sodium Bisulfate
Oil Alert® System
Sodium Carbonate,
The Oil Alert system is designed to prevent engine damage caused by
10%
an insufficient amount of oil in the crankcase. Before the oil level in
Sodium Chlorate
the crankcase can fall below a safe limit, the Oil Alert system will
automatically shut down the engine (the ignition switch will remain in
the ON position).
Sodium Chloride
If the engine stops and will not restart, check the oil level (page 9)
Sodium Nitrate
before troubleshooting in other areas.
Sodium Silicate
Sodium Sulfate
Stearic Acid
Sulfuric Acid, 0-29%
Tartaric Acid
Vinegar
Water (Clear)
ENGLISH
Soaps (neutral)
[2]
[3]
Pump Performance (maximum with clear water)
Total head [1]
Suction head [3]
Discharge capacity
Self-priming time
Pressure
Water (Salt)
Zinc Sulfate
[1]
31 m
9.5 m
850 /min
47 sec at 5 m
300 kPa