Num'axes PIE1046 Manual De Instrucciones página 28

Date format
Time stamp
Battery Type
Frequency
Cycle recording
Password
Reset
Update
Product information
10. Setting up the camera
− Mount the camera facing north or south, not east or west as the rising and setting of the sun could produce
false triggers and overexposed images.
− If you're covering a trail, face the camera down or up the trail.
− Clear out any brush or weeds in front of the camera. These can cause false triggers due to temperature and
motions disturbances in front of the camera (especially in windy days).
− Check the power level of the batteries.
− Make sure the memory card is properly inserted and have sufficient available space.
− Verify time and date are correct.
− Make sure to turn the camera ON (switch in the ON position).
11. Technical specifications
Image sensor
Effective pixels
Day/Night mode
Infrared flash range
Infrared flash setting
PIE1046 - Indice A –Septembre 2020
EU / US
EU (Europe): DD/MM/YY
US (United-States): MM/DD/YY
ON / OFF
Select "ON" if you want the date and time of the image capture imprinted on every
photo. The current temperature, moon phase, user set camera ID and GPS
coordinates (if the "GPS" parameter is set to ON) will also be imprinted on the still
photos.
Alkaline / Ni-MH (nickel-metal hydride)
The device will perform better if you select the type of the batteries used in the
camera.
You can purchase alkaline or rechargeable Ni-MH batteries at any time on
www.numaxes.com.
50Hz / 60Hz
An improper setting may cause the camera screen to flicker.
OFF / ON
When the SD card will be full, the camera will continue to record photos/videos by
deleting the oldest photos/video.
Select "OFF" then press "OK" to deactivate the cycle recording function.
OFF / ON
Select "ON" then press "OK" to enable password protection for your camera (6
digits/alphabets long password).
No / Yes
Select "Yes" to reset the camera back to the factory default settings.
Insert the SD card with the update firmware inside, then enter this menu to update
the camera firmware by confirming "Yes" in the options.
This parameter shows the following information:
Ver (firmware version in camera) / IMEI / MCU / MOD
5 Mega Pixels Colour CMOS
2560x1920
Yes
20 m (65 ft.)
60 IR LED – Wavelength: 940 nm
28/76