112G
75
100
CH1
CH1
CH2
CH2
The interface varies for Control mode and Broadcast mode. The following describes the interface
for Control mode. In Broadcast mode, operations such as adjusting recording parameters and
switching LUT cannot be performed.
1. Battery Level and External Power Voltage
The battery level will be displayed when a battery is used as the power source, while the
voltage will be displayed when an external DC power supply is used. The battery icon will
turn red
when the battery level is lower than 10%. The battery icon will be
10
the battery level is critically low. Charge the battery immediately.
2. TX Battery Level and External Power Voltage
Displays the battery level or external power voltage of the transmitting device according to
the device and power supply used.
3. Storage Capacity
Displays the available storage or the corresponding remaining recording time of the microSD
card in the monitor.
4. Remote Control Devices
Shows the connected remote control devices. See below for the corresponding device for
each icon.
: Three-Channel Follow Focus
: Left Hand Grip
5. HDMI Input Devices
This icon will appear when the HDMI port is connected to a video source.
6. Video Transmission Signal Strength and Bitrate
Tap to enter video transmission channel settings to switch the channel mode, check the
signal quality, and select the channel and downlink bandwidth.
Channel Mode: tap to switch between Auto and Manual.
In Auto mode, channels with strong interference will be avoided automatically and the
channel with the least interference and best signal quality is selected. In Manual mode,
users can manually select the channel with the best signal quality and downlink bandwidth. If
©
7
2023 DJI All Rights Reserved.
24.5M
WB
5600
ND
Clear
B
08:02:16:06
08:02:16:06
Broadcast Mode
: Master Wheels
: Right Hand Grip
SS 1/50
IRIS
F2.8
EI
800
A
B
C
D
E
F
G
H
when