RTX1000/2000, SPX1200
I
NOTE
Only install the parking cooler using the manufacturer's assembly kit.
5
Technical description
The parking cooler can be used for conditioning inside the vehicle. The air in the inte-
rior is guided into the system through the intake grille, cooled, dried and conveyed
back into the interior through the blower nozzles.
In BOOST mode, the parking cooler cools the vehicle interior for not more than
20 minutes at maximum power and then switches to AUTO mode. When the set
temperature is reached, the parking cooler switches to AUTO mode before the
20 minutes is reached.
In AUTO mode, the fan and compressor speed are controlled automatically.
In ECO mode the fan and compressor speed are controlled automatically. The com-
pressor power is limited in ECO mode electronically.
The system is controlled using the control panel or the remote control.
I
NOTE
The parking cooler can lower the temperature within the vehicle to a cer-
tain level. The temperature depends on the type of vehicle, the ambient
temperature and the cooling capacity of your parking cooler. For the
cooling capacity of your parking cooler, chapter "Technical data" on
page 24.
The system is fitted with a battery monitor. If the system is operated when the vehicle
ignition is switched off, the system switches off automatically as soon as the supply
voltage falls below a set level.
I
NOTE
This set level can be changed. For this, please contact the specialised
company that installed the system.
EN
Technical description
9