Publicidad
Idiomas disponibles
Idiomas disponibles
Disconnect the plug from the power source.
Loosen the depth adjustment lever located
between the guard and the main handle. Hold
the foot down with one hand and raise or
lower the saw by the main handle. Tighten the
lever at the desired depth setting. Check
desired depth (Fig. 3).
DEPTH SCALE
Calibrated For Standard
Lumber Sizes
DEPTH
ADJUSTMENT
LEVER
BLADE WRENCH
AND STORAGE
AREA
90° CUTTING ANGLE CHECK
Disconnect the plug from the power source.
Set the foot to the maximum depth of cut
setting. Loosen the bevel adjustment lever, set
it to 0° on a graduated quadrant, retighten the
lever and check for a 90° angle between the
blade and bottom plane of the foot with a
square. Make adjustments by turning the small
adjustment screw from the bottom side of foot,
if necessary (Fig 5).
BEVEL ADJUSTMENT
Disconnect the plug from the power source.
The foot can be adjusted up to 45° by
loosening the bevel adjustment lever at the
front of the saw. Align the bevel to the
desired angle on the graduated quadrant. To
adjust beyond 45°, depress the 45° stop
spring (Fig. 6), align the foot to the desired
mark over 45° on quadrant and tighten the
lever.
blade engagement in the work piece and
decreased stability of the foot, blade
binding may occur. Keep the saw steady
and the foot firmly on the workpiece.
Operating Instructions
DEPTH ADJUSTMENT
B e c a u s e
o f
increased amount of
Not more than one tooth length of the blade
should extend below the material to be cut, for
minimum splintering (Fig. 4).
FIG. 3
BEVEL
ADJUSTMENT
LEVER
ALIGNMENT
45°
SPRING
STOP
t h e
ONE TOOTH LENGTH SHOULD
PENETRATE WOOD FOR
MINIMUM SPLINTERING
GRADUATED
QUADRANT
90°
SCREW
GRADUATED
BEVEL
QUADRANT
ADJUSTMENT
LEVER
FIG. 4
FIG. 5
FOOT
BLADE
FIG. 6
11
Publicidad
