Publicidad
Idiomas disponibles
Idiomas disponibles
7- Filter Input 220VAC(N).
8- Output pH pump 220VAC (L)
9- Output pH pump 220VAC(N).
2) Probe connector X4:
Kits input connector: sonda agua, NTC, AUTO, ADVANCED, PRO/2 and
conductivity
1- Kit NTC / Conductivity Probe (White)
2- Kit NTC
3- Flow Switch
4- Flow Switch
5- ORP Probe (ORP-)
6- ORP Probe (ORP+)
7- Free Chlorine Probe (IN)
8- Free Chlorine Probe (24V)
9- Conductivity Probe (Black)
10- Conductivity Probe (Green)
11- Conductivity Probe (Brown)
3) ORP and Free Chlorine Probe configuration.
Set jumper positions of JP2 connector as picture shows to configure each probe
reading.
ORP:
Free Chlorine:
4) Start/Stop configuration
Remove jumper from JP1, check figure 3.3 to find its location. Connect from
filtration pump contactor output to filter input connector 220VAC cables.
PRO200-IP65 will work with Start/Stop configuration. When filtration pump is
on, Salt water chrlorinator will start production. PRO200-IP65 will stop when
filtration pump switches off. On main screen will be displayed "Stop" message.
Filter input consumption will be a few milliampers.
52 / 66
Manual PRO200-IP65 v1.0
Publicidad
