BSV BS POOL PRO200 Manual De Usuario página 60

4.1.2.1.6 Chlorine/ORP Alarm
When the unit is configured in automatic mode, it is possible to disable the
"Chloride Alarm". This alarm will detect if the ORP or PPM reading hasn't
changed for two hours or more, despite the unit has been in production.
Despite this alarm has been implemented to detect if a probe is not in good
conditions, or there is some chemical issue in the water, it can be disabled if
the user wants to maintain the production despite everything.
Note: Password "1234" is required to modify this function.
4.1.2.1.7 Buzzer
When an alarm occurs, the unit stops its production and shows an acoustic and
visual alarm to indicate that it's necessary to correct the problem.
However, it is possible to configure the acoustic signal with the following
options:
- No: Acoustic alarm is disabled
- 24h: Acoustic alarm is activated 24h.
- Adjustable: The user can adjust the time range where the buzzer is
active in case of alarm.
Note: In case of alarm, the unit will stop its production and will show the cause
on the display, regardless of the acoustic alarm configuration.
4.1.2.2- Chorine menu
With this menu you can select all parameters related to chlorine production.
4.1.2.2.1- Chlorine production
Configuration of the maximum production of chlorine.
From 0% to 100% Press "OK" and use the arrows   to change the value.
Press "OK" to confirm the adjustment.
Note: Chlorine production may be limited regardless of the operation mode
(manual, automatic...) that is selected.
Manual PRO200-IP65 v1.0
60 / 66