Publicidad
Idiomas disponibles
Idiomas disponibles
"SHORT CIRCUIT"
"OPEN CIRCUIT"
"Chlorine Alarm"
"pH Alarm"
4.3- Working hours
It may be useful to see the operation times for regular maintenance operations.
From the main screen, press both buttons at the same time.
Manual PRO200-IP65 v1.0
The
cell
is
incorrectly
connected.
Metal body in the cell.
Cell
is
incorrectly
connected.
Cell
is
damaged
completely worn down.
Swimming pool water with
very
low
concentration.
Chlorine
probe
incorrectly connected or
damaged
Water contains very low
redox potential.
The equipment does not
have a probe and is in
"automatic mode".
Empty dosing tank
pH pump problem
Probe or cable damaged
Check wiring.
Turn off the equipment and
remove the metal body from the
plates
Check the cell connection and
ensure
that
connection terminals are in good
condition.
or
Check the condition of the cell
electrodes, and replace it if any
damage is observed.
Ensure that the water has salt
salt
and that it is dissolved.
is
Check the cabling of the probe
and the probe itself. Check 5.1.
It can work in manual mode if
necessary.
Leave the equipment to chlorate
in manual mode for at least 2
hours.
Check the chemical balance of
the water. (appendix 1)
Install a Redox or Free Chlorine
probe,
or configure
mode.
Fill up dosing tank
Check wiring connections
Put it into pattern liquid. Check if
probe is working
cables
and
"manual"
65 / 66
Publicidad
