Carrier CRC2-NTC Manual Del Usuario página 3

NTC - Carrier Room Controller 2
Owner's manual
Read this manual carefully before using the appliance.
Contents
General information ............................................................................................. 2
Use ....................................................................................................................... 2
Operation ....................................................................................................... 2/3/4
A
If the fan icon is displayed: Autolouver is displayed, even if no louver is installed.
The fixed position of each single wing cannot be displayed in the louver icon, which can instead be set in the corresponding configuration
menu.
Room Controller 2
B
E D S C
Display of selected functions
A = Display
B =Key for increasing temperature/changing louver
setting
C =Key for decreasing temperature/changing louver
setting
D = Key for selecting the fan speed
E = Key for selecting the operating mode
S =Room temperature sensor
Off
Desired temperature / room temperature
Not used
*Louver position / Fan speed
Operating mode: cooling or heating
Graphic temperature display (Bar-graph)
Alarm
Page
GB - 1