Alliance Laundry Systems HC18MD2 Manual Del Usuario página 9

The wash cycle program in machines equipped with a
mechanical timer can be modified to a limited extent.
The following changes can be made:
The prewash time may be set to 2 minutes,
G
4 minutes, or omitted altogether.
The wash time may be set to either 4 minutes or
G
8 minutes. The water level for the wash step may
be set to either low or high.
The water temperature for the rinses may be set
G
to either cold or warm.
The final spin time may be set to either 2 minutes
G
or 4 minutes.
WARNING
Hazardous Voltage. Can cause shock,
burn or cause death. Turn off power
before removing control box cover and
before attempting any service
procedures.
F232133
Programming
W356
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Setting the Jumpers With Circuit
Board
NOTE: The odd-numbered side of the timer is used
to change the duration of individual cycle steps.
The even-numbered side of the timer is used to
adjust the rinse temperature or to change the water
level for the wash step.
1. Disconnect the power to the machine.
2. Unlock and raise top cover.
3. Remove control module cover.
4. Locate the mechanical timer in the middle of the
control module.
5. Install or remove jumpers on the odd side to set
desired cycle time. Refer to Figure 1 and Table 1
for jumper configurations for odd-side options.
JP1
JUMPER REMOVED
JUMPER INSTALLED
Figure 1
B165R
B165R
7