Ryobi RHT36 Manual De Utilización página 17

EN
FR DE ES
SPECIFICATIONS
Product Specifications
Model
Voltage
No load speed
Blade speed
Blade length
Cutting capacity
Measured sound
pressure level
Measured sound
power level
Vibration
Weight with
Battery pack
Battery pack
Charger
FEATURES
1. Blade cover
2. Blade
3. Hedgesweep™ debris sweeper
4. Guard
5. Sensor switch
7. Battery pack
8. Trigger lock button
9. Trigger
10. Charger
11. Latch
12. Cutting blade
13. Blade guard
OPERATION
For complete charging instructions, refer to
the Operator's Manuals for your Ryobi battery
pack and charger models.
NOTE: To avoid serious personal injury, always
remove the battery pack and keep hands clear of
the lock-out button when carrying or transporting
the tool.
IT PT NL SV DA
English (original instructions)
RHT36
36 volts
1500 /min
3000 spm
550 mm
20 mm
L =81 dB(A), K =2.0 dB(A)
PA PA
L =90 dB(A), K =2.0 dB(A)
WA WA
2
ah= 1.86 m/s , K=1.5 m/s
4.43 kg
BPL3626
BCL3620
NO FI HU CS RU
INSTALL BATTERY PACK
Place the battery pack in the hedge trimmer.
Align raised rib on battery pack with groove in hedge
trimmer. See Figure 2.
Make sure the latch on the battery pack snaps in
place and that battery pack is secured in hedge
trimmer before beginning operation.
REMOVE BATTERY PACK
Locate the latch on the battery pack and depress to
release the battery pack from the hedge trimmer. See
Figure 2.
Remove battery pack from the hedge trimmer.
When placing battery pack in your hedge trimmer,
2
be sure raised rib on battery pack aligns with groove
in hedge trimmer and latch snaps in place properly.
Improper assembly of battery pack can cause damage
to internal components.
STARTING THE HEDGE TRIMMER
Remove the blade cover.
with both hands, one hand to pull the trigger lock
button backward and squeeze the trigger, and the
other hand to squeeze the front handle.
Release the trigger lock button and continue to
squeeze the trigger for extended operation.
BLOCK RELEASE GEAR BOX
This hedge trimmer is equipped with a block
release gear box. If the blade jams, the blades will
automatically retract allowing the jam to be cleared
easily. Release the triggers, remove jammed material,
then squeeze trigger again to restart the hedge
trimmer. If the stem is too dense or too hard to be
trimmed, use a pruning saw to clear the stem.
STOPPING THE HEDGE TRIMMER
Release the trigger to stop the hedge trimmer.
Upon release of the trigger, the trigger lock button will
be automatically reset to the lock position.
Remove battery pack from the hedge trimmer.
OPERATING TIPS
Do not force the hedge trimmer through heavy
shrubbery. This can cause the blades to bind and
slow down. If the blades slow down, reduce the pace.
15 15
RO PL SL HR ET
CAUTION
LT LV SK BG