TREVIDEA GIRMI ST03 Manual Del Uso página 14

Use the appropriate refill cup to fill the tank of the boiler;
do not fill it directly under the tap or with very cold
liquids.
After ironing, drain all the water pushing the appropriate
release button, empty the tank and wait for the cooling of
all parts before storing the system.
CAUTION: the iron plate gets very hot during use, be
careful not to touch it, serious risk of burns. Do not
put face near the steam coming out the iron plate.
For correct boiler closing, press the cap while rotating.
DESCRIPTION ST03
(1) Main unit/boiler
(3) Control light: "Steam ready"
(5) Boiler power on button and working light
(7) Power cord
(9) Cap Water level control light
(11) Temperature control knob
(13) Steam button
(15) Iron cable attachment
INSTALLATION
Place the ironing system on a stable surface, away from heat sources.
Unscrew the cap (9) and fill the tank using the appropriate dispenser without reaching the maximum capacity
of 700cc. On first use, or after the iron has been unused for a long time, it is recommended to expel the steam
by pushing the button (12 and 13) for about 20 seconds. This procedure allows to eliminate any working or
limestone leftovers. For correct boiler closing, press cap while rotating it.
OPERATING THE IRONING SYSTEM
- Power on the unit by placing the knob (5) to position "1". The button will light up to indicate that the boiler
is heating up. CAUTION: when the tank control light (3) goes off, it means that the boiler is ready to
produce steam. During normal operation, the light lights on intermittently.
- Turn on the iron by switching the knob (2) to position "1". Adjust the temperature using the control knob
(11) according to the fabric to be ironed (see table at page 14). The ironing temperature control light (14),
placed on the iron, will light to show when the iron is heating up. CAUTION: when this light goes off, it
means that iron has reached the desired temperature. During normal operation, light is intermittent.
- Adjust the quantity of steam using the knob (4). For using the steam, either horizontally or vertically, press
the button (13). Use the button (12) to supply continuous steam.
CAUTION: when using the steam, wait for the complete heating of both the iron and the
boiler. In the beginning, few drops will come out together with the steam. This is normal and
it is due to the heating of the cable connecting the boiler and iron.
CAUTION: do not completely fill the tank of the boiler (max 700cc), since this operation prevents the
formation of the steam, causing the loss of water from the iron.
FILLING THE TANK
Use of demineralized water is recommended to avoid excessive fouling (not covered by warranty). The
(2) Iron power on button and working light
(4) Steam control knob
(6) Steam cord
(8) Insulating rubber base
(10) Iron plate
(12) Continuous steam button
(14) Cork iron
(16) Iron body
13