Publicidad
Idiomas disponibles
Idiomas disponibles
capacity of the tank is 700cc. It is compulsory filling up the tank when it comes out of water or when the
indicator light (3) turns off during use. Follow the steps below for filling the tank:
1)
Stop the heating boiler by switching the control knob (5) to position "0".
2)
Let the steam comes out from the boiler by pressing the button (13).
To avoid any risk of injury, always eject the steam before opening the cap of the boiler.
3)
Remove the plug from the main power outlet and wait until the pressure goes down.
4)
Slowly unscrew the boiler cap (9) to release remaining steam and lower the pressure. The air coming out
is very hot, be careful and unscrew the cap of the boiler very slowly.
5)
Fill in the tank using the cup and the funnel without exceeding the maximum capacity.
CAUTION: do not completely fill the tank of the boiler (max 700cc), since this operation
prevents the formation of steam causing the loss of water from the iron.
TEMPERATURE SETTING
The following table provides a guideline on how to adjust the thermostat according to the international
symbols printed on the clothing labels or according to the type of fabric.
•
It is recommended ironing clothes that require low temperatures first and then medium and high
temperatures. This operation allows to save time since the ironing plate heats faster than it cools down.
In the case of blend fabric(Ex: Acrylic and cotton), it is recommended to select the temperature
according to the fabric that requires the lowest.
•
When you do not know the composition, it is recommended to iron a non-visible part of the it, starting
from the lowest temperature to find the most suitable temperature.
•
Sometimes the clothing becomes shiny, in this case you need to iron it on the inside not to ruin it. When
ironing at maximum temperature (MAX), it is recommended to place a cloth between the ironing plate
and the fabric.
Setting the temperature
1)
Place the iron on the insulated rubber housing above the boiler.
2)
Plug the system to the electrical outlet, and switch the power button (6) to "1" position.
3)
Select the temperature regulator (11) according to the symbols shown on page 7. The chosen symbol
has to be aligned with the mark placed on the body of the iron. The iron plate temperature control light,
placed on the side of the iron, shows that the iron plate is warming up. Wait until the light turns off to
start ironing.
Caution: While ironing, the control light lights up periodically indicating that the temperature is constant. If
you lower the thermostat, do not start ironing until iron temperature control light turns off.
STEAM IRONING
Before using the steam, check the water level first. The steam that the boiler supplies to the iron can be
adjusted with the steam control (4). Place the steam control between minimum and maximum depending on
the quantity of steam and the temperature selected.
LABEL
FABRIC
Synthetic
(Acrylic, nylon...)
silk – wool
cotton – linen
TEMPERATURE
·
Low temperature
··
Medium temperature
···
High temperature
Do not iron
14
Publicidad
