Domo DO7292S Manual De Instrucciones página 28

Idiomas disponibles

To prevent losing suction after emptying the dust container, it is essential that the filter be cleaned

regularly.

Remove the filter from the dust container.

Remove the sponge and clean both parts thoroughly under running water. Allow them to dry

completely before replacing them in the vacuum cleaner.

CLEANING OR REPLACING THE HEPA FILTER IN FRONT OF THE AIR OUTLET

At the back of the appliance there is a grille for the HEPA filter. You can easily remove it by pushing

down on the cover and taking the grille out of the appliance.

Remove the sponge from the grille and clean it under running water.

Take the HEPA filter out of the appliance by pulling it toward you. Clean the filter under running

water or replace it if necessary.

Make sure that the parts are completely dry before replacing them in the vacuum and the using the

appliance again.

ATTENTION

In a normal cleaning session, it is sufficient to tap out the filters. It is recommended that you

thoroughly clean the filters under tepid running water 3 to 4 times per year. Make sure that it is

completely dry before putting it back in the appliance. You can also replace them if necessary. Avoid

direct sunlight or intense overheating. Never put the filters in the washing appliance to prevent

deformation. Do not use abrasive or cleaning products and wash from the bottom of the filter.

Make sure that all components are correctly assembled before using the vacuum cleaner again.

Always use the vacuum cleaner with the filters intact. If you do not do this, you may lose suction force

or damage the motor.

Unplug the plug before cleaning the filters.

Do not use a hairdryer to dry the filters.

DO7292S