Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2610033029 10-13_BM 2610033029 09-13.qxp 10/1/13 11:49 AM Page 9
Disconnect battery pack
W RNING
from tool before making
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
INSERTING AND REMOVING
ACCESSORIES
(Model IDH182 only)
To avoid loss of control,
W RNING
ensure bit is locked in chuck
by pulling on bit after it has been inserted.
The chuck accepts only standard 1/4"
hexagonal shank accessories with power
groove.
Your tool is equipped with a Socket-Ready™
quick release chuck. The Socket-Ready™
chuck includes a 1/4" hex chuck designed for
impact ready bits and accessories and a 1/2"
square drive for use with impact wrench
sockets.
When using the 1/4" hex chuck insert a bit or
accessory by simply pulling the locking sleeve
forward and inserting the desired accessory
into the chuck and release locking sleeve (Fig.
2). To remove a bit or accessory, pull locking
sleeve forward and simply remove it from the
chuck.
(Model IWBH182 & IDH182 only)
When using the 1/2" square drive, attach only
high quality impact ready accessories with the
proper size square drive designed for use with
impact wrenches. To install a socket, simply
push completely onto output drive.
INTENDED USE
This tool is intended for the fastening and
loosening of bolts, nuts and various threaded
fasteners. This tool is not intended for use as a
drill.
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
Assembly
FIG. 2
SCREWDRIVER
BIT HOLDER
FIG. 3
Operating Instructions
to increase the speed and release pressure to
decrease speed (Fig. 1).
When the trigger switch is released it
activates the brake to stop the chuck quickly.
This is especially useful in the repetitive
driving and removal of screws.
VARIABLE SPEED CONTROL SELECTOR
The speed of the power tool can be adjusted
by toggling the variable speed control on the
foot of the drill. The speed of the drill is
indicated by the indicator lights at the foot of
-9-
LOCKING SLEEVE
CHUCK
BIT
SCREWDRIVER BIT
SOCKET
OUTPUT
DRIVE
BRAKE
Publicidad
