Schneider Airsystems AM 4-10 E1 Manual De Instrucciones Original página 11

Contact your service partner.
12.7 Max. pressure 14 bar
Possible causes:
1. Safety valve is defective
2. Electronics fault/defective
Remedy:
1. Replace the safety valve.
2. Contact your service partner.
12.8 PTC ventilator
Have a trained and qualified electrician re-
place the ventilator.
13 Warnings
If a warning is registered, the compressor is
not switched off. L2 flashes in 500 ms cycles.
The warning display can be acknowledged by
pressing T5. L2 continues to flash until the
warning is rectified. Once the warning is rec-
tified, press T5 to acknowledge.
13.1 High oil temperature
See chapter12.3
13.2 Attn: Maintenance
Please arrange a maintenance appointment
with your service partner.
14 Circuit diagram
see Fig. 5a
15 Vessel inspections
AM x-10 E1 180 (DK z):
Compressor with type test: Inspection re-
quired prior to commissioning by "qual-
ified person".
Type identification: see compressor type
plate
We recommend that a "qualified person"
perform a pressure test on the vessel, de-
pending on its rate of utilisation, after 10
years in accordance with the Ordinance on
Industrial Safety and Health. Contact any of
our service partners.
It is essential to retain vessel documents
included in the delivery (= certification
documents) and inspection documents for
the entire service life of the vessel. The
statutory specified inspections must be
arranged in accordance with the applica-
ble regulations of the respective country
in which the vessel is used.
AM x-10 E1 270 (DK z):
An informal inspection book (collection of all
documents related to the vessel including in-
spection documents from the "approved test
centre") must be compiled for the vessel.
Register the vessel with an "approved test
centre", stating this data. The centre initiates
and certifies an installation check by an
authorised expert and specifies the inter-
vals for repeat inspections.
It is essential to retain vessel documents
included in the delivery (= certification
documents) and inspection documents for
the entire service life of the vessel. The
statutory specified inspections must be
arranged in accordance with the applica-
ble regulations of the respective country
in which the vessel is used.
16 Warranty
Basic principle: complete unit in original
condition / proof of purchase.
Material and production defects are covered
by statutory provisions.
Excluded warranty claims: Wear/consum-
able parts; improper use; overload; manipu-
lation/use for other than intended use;
insufficient/incorrect/no maintenance; accu-
mulation of dust/dirt; incorrect/impermissi-
ble work methods; failure to observe the
Instruction Manual; incorrect processing/
working materials; incorrect electrical con-
nection; improper installation.
GB
AM x-10 E1
7