Publicidad
Idiomas disponibles
Idiomas disponibles
Commissioning and temperature setting
Commissioning
After waiting 48 hours, plug in your wine cabinet, having checked that your socket is correctly
supplied with power.
(presence of correct sized fuses, circuit breaker in working order. If need be, plug in another electrical
appliance to check the power supply).
Temperature setting
Description of the control panel
•
•
•
•
Status lights:
Compressor 1 : indicates that the compressor is operating. When this flashes, it means that the
compressor is going to start up in a few minutes (technical delay).
Defrosting cycle 2 : indicates that an automatic defrosting cycle is underway.
Heater 3 : indicates that the heater is operating.
Alarm 4 : informs you that there is an abnormally high or low temperature inside the wine cabinet.
Commissioning the control panel
By default, the control is in the OFF position. To switch on the cabinet, press and hold the ( ) button for
several seconds until just the temperature is displayed.
To put the cabinet on standby, press and hold down the ( ) button for several seconds. The display
switches between the internal temperature and the OFF display (the cabinet is no longer operating, only
the display is active).
To reactivate the cabinet back on, press and hold down the ( ) button for several seconds until just the
temperature is displayed.
To set the temperature of your wine cabinet
The temperature of your wine cabinet is set entirely from the control panel.
1 temperature models
(OXYVD8WCOUS / OXYVG8WCOUS / OXYP1TVD4WCOUS / OXYP1TVG4WCOUS):
Press and hold down the SET button for a few seconds until the temperature setting (ST1) flashes.
•
•
The recommended setting range for aging wine is 50°F - 57°F. The default setting is 54 °F. However, the
temperature may also be set between 48°F and 59°F.
Your wine cabinet can be placed in a room with a temperature of 32°F - 86°F.
12
1
2
3
4
Temperature display: displays the actual temperature inside your wine cabinet. It is therefore
necessary to wait before your new setting takes effect.
Simply press and hold down SET for a few seconds to see the temperature setting.
Buttons (
/
/ SET) : allow you to select the desired temperature inside the cabinet.
Standby button ( ) : allows you to switch the cabinet on and put it on standby.
Set the desired temperature using the
Confirm your programming by pressing the SET button. If you do not confirm your setting
with this key, your modification will not be registered.
and
buttons.
Publicidad
