Descargar Imprimir esta página

Avanti NIMD3313S-IS Manual De Instrucciones página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

Unpacking Your Ice Maker
1. Remove all exterior and interior packaging. Make sure that the ice basket and ice scoop are
included. If any part or accessory is missing, please contact our customer service department.
2. Clean the interior with lukewarm water and a soft cloth. Remove the ice basket and wash it in
warm water.
3. Clean the evaporator rods using a water/vinegar solution.
4. Find a location for your ice maker that is protected from direct sunlight and you will need six inches
of space between the back and sides of your ice maker and the wall.
Connecting Your Ice Maker
1. This unit should be properly grounded for your safety.
2. Plug the appliance directly into an appropriate 120V AC outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
WARNING: Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged, please call our customer service department.
Using Your Ice Maker
1. Press the "ON/OFF" button after plugging in the ice maker machine and it will begin to run.
Tip: You can use drinking water.
2. Open the cover, remove the ice basket and pour water into the tank, make sure it does not surpass
the maximum water level. Put the ice basket back into the machine and close the lid.
Tip: Keep the water below the ice basket.
3. While the ice maker is on, check the water level periodically. If the water pump cannot inject
water, the ice maker will stop automatically and the "Add water" indicator will be on. Press the
"ON/OFF" button, fill water up to the level mark and press the "ON/OFF" button again.
4. The ice maker automatically stops working when the ice basket is full. The "ICE FULL" indicator
will light up when the ice bucket is full. To restart ice making, please remove the ice and then press
"ON/OFF".
5. Change the water in the water reservoir every twenty-four hours to ensure a reasonable hygiene
level. If the unit is not in use for a few days, drain all the water in the tank reservoir and refill
before operating again.
6. Minimum water level is 1.5" and the max water level is 3". The "ADD WATER" indicator will light up
when the water level is low. To restart, please add water and then press "ON/OFF" button.
7. For best performance, water temperature should be between 7°C (45°F) and 35°C (95°F) and
ambient between 15°C (59°F) and 25°C (77°F).
8. Actual ice making capacity will depend on the ambient temperature of the surroundings of the ice
maker as well as the temperature and quality of the water used to make the ice.
Operating Instructions
10

Publicidad

loading

Este manual también es adecuado para:

Nimd3314bs-is