JVC KD-SR82BT Manual De Instrucciones página 8

GETTING STARTED
1
Cancel the demonstration
When you turn on the power for the first time (or [FACTORY RST] is set to
[YES]), the display shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB"
1
Press the volume knob.
[YES] is selected for the initial setup.
2
Press the volume knob again.
"DEMO OFF" appears.
2
Set the clock
1 Press and hold .
2
Turn the volume knob to select [CLOCK], then press the knob.
3
Turn the volume knob to select [CLOCK SET], then press the knob.
4
Turn the volume knob to make the settings, then press the knob.
Day Hour Minute
5
Turn the volume knob to select [24H/ 12H], then press the knob.
6
Turn the volume knob to select [12 HOUR] or [24 HOUR], then press the
knob.
7
Press to exit.
To return to the previous setting item, press
4
3
1 Press and hold
2 Turn the volume knob to select an item (see the following table),
then press the knob.
3 Repeat step
4 Press
To return to the previous setting item, press
SETTINGS
BEEP
SRC SELECT
AM *
PANDORA *
IHEART *
AUX *
F/W UPDATE
SYSTEM
F/W xxxx
.
FACTORY RST YES: Resets the settings to default (except the stored station). ; NO: Cancels.
* Not displayed when the corresponding source is selected.
Set the basic settings
.
2 until the desired item is selected or activated.
to exit.
(Not applicable when 3-way crossover is selected.)
ON: Activates the keypress tone. ; OFF: Deactivates.
ON: Enables AM in source selection. ; OFF: Disables.
ON: Enables PANDORA in source selection. ; OFF: Disables.
ON: Enables IHEARTRADIO in source selection. ; OFF: Disables.
ON: Enables AUX in source selection. ; OFF: Disables.
YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not
activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
.
Default: XX