UFESA BC1100 Manual De Instrucciones página 10

3. Place the battery in the location indicated under the cover with the positive polarity that is visible at all times.
4. Close the cover again
5. Place the appliance on a horizontal, solid, rigid, flat, stable surface that is free of vibration.
6. Pressing the power button will display "88888," then displaying value zero (when the scale is in the correct
position, a triangle appears to indicate that the weight is stabilized). If you wish to change the measurement, press
the unit button and choose either g, oz:lb, ml of water, ml of milk, water cup, milk cup. Once you do this, it is ready
to weigh.
7. This scale has a tare function that enables different products to be weighted without the need to empty the
container you are using. Place the container once it is turned on and press the Tare button, which will display the
icon"-0-"indicating that it is set to 0 and then 0 will appear. Place the first product to be weighed and press the Tare
function again and 0 will appear again, and so on until all the items have been weighed.
8. Keep the on button pressed down for a few seconds and it will turn off, otherwise it will turn off in2 minuteswhen
pressed.
9. Replace the appliance in a safe place.
CONTRAINDICATIONS
This product is for domestic use only and not intended for professional use.
Children should be supervised by an adult in order to prevent the device being used as a toy.
This appliance is not intended for use by persons (including children) with any reduced physical, sensory or mental
capacities, or who who do not the sufficient experience and knowledge necessary, unless they aresupervised by a
person responsible for their safety.
REPAIRS
Only specialised personnel may carry out repairs on electrical devices. Any incorrectly performed repair may lead
to considerable danger to users. Please contactafter-sales service for any repairs. Failure to follow the instructions
entail the total loss of the product guarantee.
TROUBLESHOOTING GUIDE
Possible operational problems
PROBLEM
The device does not work.
Message "LO"
Error message "EEEE"
10
CAUSE
The device is not turned on or the
battery is not properly in place.
Battery worn out
The appliance is damaged.
Low battery indicator
Overload
SOLUTION
Check that the battery is placed with the
proper polarity.
Replace the batteries with new ones
Contact technical customer service.
Replace the batteries.
This means that the maximum weight has
been exceeded