Safety Rules - Daitsu ADP 9AM Manual De Instrucciones

07ManPORTATILDaitsuEng 7/2/07
1-
Do not connect unit to any ac socket in disrepair or with connections.
2-
Do not use in the following locations:
- Next to source of fire.
- An area where oil is likely to splash.
- An area exposed to direct sunlight.
- An area where water is likely to splash.
- Near a bath, a shower or a swimming pool.
- In the green house.
3-
Never insert your fingers or any foreign objects into the air outlet. Take special care to warn children of these dangers.
4-
Always store the unit upright in order to maintain the compressor in a proper condition.
5-
Be sure to unplug the unit before cleaning.
6-
The heater must not be located immediately below a socket outlet.
7-
If the appliance is covered, there is a risk of overheat.
8-
If the supply tool of this appliance is damaged, it must be replaced by a repair shop appointed by the manufacturer, because
special purpose tools are required.
Note: The air-conditioner can be connected only to a supply with system impedance no more than 0.4582 ohm. But the system
impedance should be at least 0.257ohm (For 9000Btu/h models) or 0.208ohm(For 12000Btu/h models).
In case necessary, please consult your supply authority for system impedance information.
32
10:13 Página 32

SAFETY RULES