Philips AVENT SCD503 Manual De Usuario página 8

7.2 Linking parent unit and
baby unit
Press and hold the 3 button on the baby
1
unit for 3 seconds until the power-on light
lights up.
Press and hold the 3 button on the
2
parent unit for 3 seconds until the 'link'
light starts flashing red.
•
When the parent unit and baby unit
are linked, the 'link' light turns solid
green.
•
If no connection is established, the
'link' light continues to flash red
and the parent unit beeps.
What to do if no link is established
•
If the parent unit is out of range, place it
closer to the baby unit.
•
If the baby unit or parent unit is too
close to another DECT appliance (e.g. a
cordless phone), turn off this appliance
or move the unit away from this
appliance.
•
If the baby unit is turned off, turn it on.
7.2.1 Operating range
•
The operating range is up to
300 meters/985 feet outdoors and up to
50 meters/150 feet indoors.
•
The operating range of the baby
monitor varies depending on the
surroundings and factors that cause
signal attenuation.
Wet and moist materials cause so much
signal attenuation that the range loss is
up to 100%. For signal attenuation from
dry materials, see table below.
8