Samsung SCC-B2037P Manual Del Usuario página 22

How to use OSD Menu
❖
V-SYNC
Select the vertical sync mode for INT or LINE.
If you select INT, the camera will use the internal
synchronization.
If selecting LINE, the camera will use the external
power source frequency for the synchronization.
You can adjust the LL-PHASE.

Note :
Use of DC 12V will fi x V-SYNC to INT, which can not be
–
changed.
❖
AGC COLOR SUP
Adjust the color scheme according to the AGC
value.
❖
REVERSE
Mirrors video signals horizontally, vertically, or
both.
❖
POSI/NEGA
Output as it is or mirror the video brightness
signal.
❖
PIP
Displays a sub image together with the main
image on the same screen using the Picture In
Picture function.

Note :
If more than one privacy zone is set and the PRIVACY
–
SET is set to ON, the PIP function will be deactivated.
If the INTELLIGENCE function is set to FENCE mode, the
–
PIP menu will be deactivated.
❖
DIS
Digital Image Stabilization will set the anti-shake
compensation.

Note :
If you set DIS to ON, the compensation area will be
–
enlarged as set in the digital zoom factor.
If you set the digital zoom factor to greater than the
enlarged zoom factor for the compensation, the DIS
function will be deactivated.
22 – DIGITAL COLOR CAMERA
[INT, LINE]
[LOW , MID, HIGH]
[OFF, H, V, H/V]
[+, -]
[OFF, ON]
[OFF, ON]
INTELLIGENCE
INTELLIGENCE
MOTION
ADVANCED
MASK AREA
DISPLAY
SENSITIVITY
RESOLUTION
ALARM OUT
You can set the motion detection and tracking in the
INTELLIGENCE menu.
❖
MOTION [OFF,TRACKING,DETECTION]
• TRACKING
Detects and tracks a moving object.
• DETECTION
Detects a moving object.

Note :
If it is set to DETECTION, you can not set such functions as
–
FIXED/MOVED and FENCE in the ADVANCED menu.
❖
ADVANCED
Detects a motion of an object and displays an
image of any moving object before tracking the
moving route.
• FENCE
This is to detect if a moving object passes
through the specifi ed LINE or AREA.
In a condition where a moving object is detected
in an analysis of the previous and current frames
whose movement overlaps a certain area, the
system displays "PASS" if the object's center line
passes through the line while it displays "ENTER"
or "EXIT" if the center point passes through the
area.
OFF
OFF
1 2 3 4
ON
[4]
[5]
[OFF, FIXED/MOVED, FENCE]