Publicidad
4.
Install the Spout
Apply plumbers putty.
Appliquer du
mastic de plombier.
Aplique masilla
de plomería.
Setscrew
Vis de retenue
Tornillo de fijación
Setscrew
Vis de retenue
Tornillo de fijación
Confirm there are three setscrews pre-installed in the wall flange and not
protruding into the inside diameter of the wall flange. Adjust as necessary.
Apply plumbers putty or other suitable sealant to the back surface of the wall
flange. Refer to the putty manufacturer's application instructions.
Slide the wall flange over the spout tool (not shown).
Position the three holes on the wall flange at the 2, 6, and 10 o'clock positions,
then secure the wall flange with three wood screws.
Remove the spout tool.
Temporarily place the escutcheon on the wall flange.
Thread the spout onto the mixer valve until the spout is fully seated and vertically
level. If necessary, unthread the spout for adjustment.
Slide the escutcheon away from the finished wall so that the setscrew holes of the
wall flange can be accessed.
Thread three wood screws (not provided) into the wall flange until the setscrews
contact the spout. Fully tighten the wood screws.
Slide the escutcheon back against the finished wall and onto the wall flange.
With the setscrew hole at the 6 o'clock position, secure the escutcheon with a
setscrew.
Kohler Co.
Setscrew/Vis de retenue/Tornillo de fijación
Wall Flange/Bride murale/Brida mural
Setscrew/Vis de retenue/Tornillo de fijación
Wood Screws/Vis à bois/Tornillos para madera
Escutcheon/Applique/Chapetón
Level
Niveau à bulle
Nivel
9
Spout
Bec
Surtidor
1141147-2-A
Publicidad
