Publicidad
Idiomas disponibles
Idiomas disponibles
24
clean them using a needle or pin.
• Replace the steam nozzle by inserting it and
vigorously turning it upwards into the steam spout.
• Replace the milk frother by pushing it upwards and
turning it counter-clockwise.
15.6 Cleaning the Brewing System:
Warning: The brewing system can only be removed
when the machine is off. Attempting to remove the
brewing system with the machine on will risk causing damage.
Note: The brewing system must be cleaned very
frequently (depending on use) to prevent it from
filling with coffee deposits (that may lead to
malfunctions). To clean it, proceed as follows:
• Make sure the machine is turned off, but do not
unplug it. Wait for all indicator lights to go off.
• Open the service door (Figure 24)
the dishwasher.
• Carefully clean the inside of the machine by
scraping it with a plastic or wooden fork (Figure 26)
and then pick up all the residues using a vacuum
cleaner (Figure 27)
• Replace the brewing system by sliding it onto the
supports and the pin at the bottom. Then push the PUSH symbol fully in
until you hear a click.
Check that the two red buttons have opened back out, otherwise the
service door cannot close properly.
• Remove the cup
support and used coffee
container and clean
them (as noted above)
• Press the two red
release buttons on the brewing system
(Figure 25) and pull it
out.
• Wash the brewing
system under running
water, without using
detergents. Never place
the brewing system in
Figure 24
Figure 25
Figure 26
Publicidad
