Descargar Imprimir esta página

Chamberlain C253 Manual Del Propietário página 35

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
Using your Garage Door Opener
The garage door opener can be activated through a wall-mounted door control, remote control, wireless keyless entry
or myQ accessory.
When the door is closed and the garage door opener is activated the door will open. If the door senses an obstruction
or is interrupted while opening the door will stop. When the door is in any position other than closed and the garage
door opener is activated the door will close. If the garage door opener senses an obstruction while closing, the door
will reverse. If the obstruction interrupts the sensor beam the garage door opener lights will blink 10 times. However,
you can close the door if you hold the button on the door control or keyless entry until the door is fully closed.
The safety reversing sensors do not affect the opening cycle. The safety reversing sensor must be connected and
aligned correctly before the garage door opener will move in the down direction.
Push Button Door Control
SYNCHRONIZE THE DOOR CONTROL: To synchronize the door control to the garage door opener, press the
push button until the garage door opener activates (it may take up to 3 presses).
Push Button
LIGHT Button
Remote Control and Keyless Entry
Pre-programmed remote control included, no need to program the remote.
To add or reprogram a remote control, follow the instructions below. Older Chamberlain remote controls are NOT
compatible, see page 40 for compatible accessories.
PROGRAM USING THE DOOR CONTROL
1.
Press and immediately release the Learn button.
2.
Remote Control: Press and hold the button on the remote control that you wish to use.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry
keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed. Repeat
the steps for programming additional remote controls or keyless entry devices.
1
2
OR
To watch a video, go to tinyurl.com/lcsf6xt
®
HomeLink
If your vehicle is equipped with HomeLink, a Compatibility Bridge
vehicles. Visit bridge.chamberlain.com to find out if a Bridge is needed.
35
LEARN Button
LEARN LED
?
?
?
?
PIN
TM
(not included) may be necessary for certain

Publicidad

loading