LED flashes
Continuously
(flashes ON/OFF twice in
(500ms ON/OFF)
500ms, then OFF for 2
—
Table 5 - Indications of the dialers status from the Green LED's.
OPERATING PRINCIPLES
Once the language is selected, the voice menu for programming will become active in the language chosen. The
interface language can also be changed, either from a menu in the corresponding section or by using a keypad
sequence (see section "Advanced Management->Language change"). This also allows the device to be programmed
in one language and then operated in another one.
When the device is turned on, no voice or text messages are sent until the radio module is completely initialized. Any input
activation will be ignored. If the dialler is not capable of performing the command associated with the activation of an input, the
command will be memorized and executed when the device returns to being ready, which allows for the handling of multiple
messages due to the simultaneous activation of multiple inputs. For optimal installation of the device, search for the operator
with the best coverage.
Priority management
The BTEL-3G can send voice and text mesages. Text messages have a higher priority compared to voice messages.
If at the end of a voice message, there are text messages to be sent with the activation of another input, the latter are sent
before any other voice mesages.
IMPORTANT - Input no. 1 (L1) takes priority over the other inputs: if input no. 1 (L1) is activated, the
call cycles related to it are carried out, even if at that moment the dialler was going through cycles
linked to a different input.
For example, if an alarm takes place on input 2 and a few seconds later, an alarm occurs on input 1, the BTEL-3G stops sending
the voice message originating from input 2 and then sends the voice messages connected with input 1. Once it has finished
sending the voice messages for input 1, the BTEL-3G starts sending the voice messages in the queue originating from input 2
once again.
Event
Event taking place
Priority
Sending SMS
1 (HIGH)
message
Sending voice
2
message
When multiple inputs are activated, the alarms are placed in a queue and they are cancelled only at the
end of all the programmed actions for every input.
To program call cycles, see the section "Parameters Management->Management options calls".
Programming sets a series of parameters needed for the BTEL-3G to work, enabling it to adapt to the particular type of
installation and use desired. The Installer menu can be accessed via the system's keypad
Installer menu is shown below.
10
BTEL-3G dialler status indication
Intermittently
seconds)
—
Table of Priority Handling
Action to activate input channel 1 (L1)
When finished sending the message, the actions concerning input channel 1 will be
The call is completed, the events are placed in a queue and they will be ransmitted
at the end of input channel 1's alarm cycle.
PROGRAMMING
Meaning
Problem with the SIM card
The dialer is initializing; flash until a GSM signal is
received
carried out.
. A block diagram of the
BTEL-3G