Publicidad
Idiomas disponibles
Idiomas disponibles
Do not route any wiring over circuit boards.
This Device shall be installed by qualified SERVICE PERSONS only, in the shelter of a safe and dry site,
away from radio-transmitting equipment.
Test the GSM Network reception before mounting this Device in the proposed placement.
Mounting
This paragraph describes how the BTEL-3G is installed.
Numbers in bold type between square brackets refer to the parts in Fig. 1, unless indicated otherwise.
1. Remove the cover by unscrewing the four screws [1].
2. Mark the position of the holes [6] required to fix the metal base [5] to the wall.
3. Drill holes in the wall as marked.
! ! ! ! !
Check for cable conduits and water pipes before drilling.
4. Pass the connection cables through the opening on the base [10].
5. Fix the metal base to the wall using wall anchors (not supplied).
6. If necessary, assemble the Wall Tamper Switch (optional) [8] as shown in Figure 1.
The switch lever must be directed as illustrated in Figure 1, otherwise the device will not work
correctly.
7. Arrange the connections to the terminal box [21] as described in the section "Connecting the device".
8. Connect the connector [20] to the battery with the wire [11].
! ! ! ! !
Use only batteries sealed.
Connect the terminals of the tamper switch [16] (see the section "Connecting the device") to the
tamper line or to an appropriate area of the alarm system. Read the instructions for the alarm system
for further information.
After the BTEL-3G is installed, it may be necessary to remove the front panel for maintenance or repair
purposes. Bear in mind that if the tamper switch [16] is connected to the corresponding line of an anti-
intrusion system, the latter can cause an undesired alarm. Therefore, before removing the front panel
of the BTEL-3G, make sure that the panel's alarm group is disabled (refer to the control panel's
instructions for information on how to disable the alarm group).
9. Following the arrow, insert the SIM-CARD face down in the SIM holder [22] (see Figure 1).
The PIN for the SIM CARD must be disabled before inserting it in the SIM holder.
10. When you turn it on, check whether all the green LED's are blinking; in this case, the BTEL-3G is initializing.
11. Checking Signal Strenght :
– make sure that at least one of the green LEDs remains lit; all green LEDs lit indicates optimal coverage;
– if the green LEDs are not illuminated, the signal strength is TOO WEAK; change the position of the antenna until
you find a position which offers acceptable signal strength, at least one LED illuminated.
12. Close the BTEL-3G: place the cover [2] on the baseplate [5]; fix the cover by tightening the screws [1]. Close the control
panel cover.
! ! ! ! ! Before inserting or removing the SIM card, please ensure the unit is powered down.
3G/2G Telephone dialler
INSTALLATION
EN
7
Publicidad
