Publicidad
Idiomas disponibles
Idiomas disponibles
Management Repetitions of Voice Messages
To program the number of times that voice messages will be repeated, type the following keypad sequence:
where <Number of repetitions> corresponds to the number of repetitions requested (from
setting for the number of repetitions is 1 (to send the voice message only once).
Management Call Cycles
When an alarm event takes place, the phone numbers in the phone book associated with the triggered input are called
(in the order that the phone numbers are saved in the phone book) and the programmed voice messages are played.
By programming call cycles, you can keep trying to call numbers that for some reason have not answered their call (no
answer, busy, or unreachable). If the call is successful, the dialer will not call the subsequent numbers, unless the "Call
All " option has been enabled. Program the number of times a call is attempted for each programmed telephone number
by entering the following formula:
where <Call Cycles> corresponds to the number of times the call cycle must be repeated (from
default setting for call cycles is 1 (perform only one call cycle). The call cycles are enabled at increasing intervals: after
1, 2, 5, 10, 15, 20, 25, and 30 minutes.
Input no. 1 (L1) takes priority over the other channels; if input no. 1 (L1) is activated, its call cycle is
performed, even if at that moment the call cycle of a different input was under way.
Management Call All
When an input is activated, a message is sent to all the telephone numbers linked with that input, continues calls even if
one of the numbers answered.To program this feature, type the following keypad sequence:
Management Call Confirm Result
If this option is enabled, the BTEL-3G considers only voice calls that were confirmed by the user to be successful. If "Call
Confirm Result": is enabled, the person answering will need to confirm receipt of the call after receiving the voice
message and before the dialer ends the call by pressing the
the
or the
key is pressed, the call will not be considered successful and the programmed call cycle will be
executed (see the section "Management Call Cycles"). To program this feature, type the following keypad sequence:
If the "Call Confirm Result" feature is enabled, pressing
allows access to the voice menu.
In some cases the BTEL-3G may misinterpret the answer from answering machines, ringback tones,
GSM operator courtesy messages, etc. Users are advised to enable the "Call Confirm Result" function.
14
<Number of repetitions>
<Call Cycles>
<Call Cycles>
(to Enable)
(to Disable - factory default setting)
or the
(to Enable)
(to Disable - factory default setting)
key on their own telephone (DTMF). If neither
ends the call immediately, while pressing
to
). The factory default
to
). The factory
BTEL-3G
Publicidad
