Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
CLEANING THE LED LENS
See Figure 48.
Over time the LED light may become cloudy or dull. If this
occurs, the LED lens may require cleaning.
To clean the lens:
Unplug the saw.
Raise the saw arm.
Remove the blade as described in the Assembly section.
Rotate the lower blade guard to expose the LED lens.
Using a small cloth or a cotton swab, gently clean away
any dirt or debris from the LED lens.
NOTE: Use caution when cleaning to avoid damaging
the lens.
Reinstall the blade.
ACCESSORIES
Look for these accessories where you purchased this product or call 1-866-539-1710:
AC9946 Miter Saw Utility Vehicle .......................................................................................................................994670001
Dust Bag Assembly ......................................................................................................................................089036008914
10 in. Blade (40 Tooth) .................................................................................................................................089036008911
Zero Clearance Throat Plate ........................................................................................................................089036008155
Work Clamp .................................................................................................................................................089036008029
Blade Wrench ...............................................................................................................................................089036008028
WARNING:
Current attachments and accessories available for use with this product are listed above. Do not use any attach-
ments or accessories not recommended by the manufacturer of this product. The use of attachments or acces-
sories not recommended can result in serious personal injury.
LED LENS
34 - English
COTTON
SWAB
Fig. 48
Publicidad
