Descargar Imprimir esta página

Roadstar CDR-380CD Manual De Instrucciones página 4

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
Safety Precaution
Do not allow this unit to be exposed to rain or moisture.
Mains Supply: AC230Volts / 50Hz - AC only
This symbol means that this unit is double insulated. An earth connection is not required.
POWER SUPPLY
Remove the stereo carefully from the box, retaining the packaging for future use.
Please read this instruction book carefully before operating this unit.
AC Power Operation
Plug the supplied AC power cord into the AC power socket on the back of this portable
stereo. Connect the AC Power Cord to your AC household mains outlet and switch on the
mains supply. Make sure the voltage is compatible.
Battery Operation
Remove mains lead from the unit for battery operation.
Open the Battery Compartment (7) at the bottom of the stereo and insert six UM-2 batteries
following the polarity diagram shown inside the battery compartment.
Batteries should be removed form the compartment if the unit is not to be used for some
time.
Flat batteries should be removed from the unit to avoid leakage.
RADIO OPERATION
1.
Set the Function Selector (3) to RADIO position.
2.
Tune to the desired radio station by turning the Tuning control (5).
3.
Adjust the Volume (8) control to the desired level.
4.
To turn off the radio, set the Function Selector (3) to the OFF position.
Antenna
For FM reception there is a built-in telescopic FM antenna (1) at the rear of the unit. Extend the
antenna and move it around to obtain the best reception.
For MW reception the signals are picked up through a built-in ferrite antenna. Your may have to
orient the unit to obtain the best reception.
COMPACT DISC OPERATION
To remove a disc from its storage case, press down on the centre of the case and lift the
disc out, holding it carefully by the edges.
Fingerprints and dust should be carefully wiped off the disc's recorded surface with a soft
cloth. Unlike conventional records, compact discs have no grooves to collect dust and
microscopic debris so gently wiping with a soft cloth should remove most particles. Wipe in
English
3
CD PLAYBACK
Loading and Unloading Compact Discs
1.
2.
3.
4.
The total number of tracks appears on the display: Press the PLAY/PAUSE (II ) (16) to start
During playback, the actual track appears.
5.
6.
7.
8.
Notes:
LOCATING A PARTICULAR TRACK OR POINT OF THE TRACK
1.
2.
3.
English
4
a straight line from the inside to the outside of the disc. Small dust particles and light stains
will have absolutely no effect on reproduction quality.
Never use chemicals such as record sprays, antistatic sprays, benzine, or thinners to clean
compact discs. These chemicals can irreparably damage the disc's surface.
Discs should be returned to their cases after use. This avoids serious scratches that could
cause the Laser pickup to skip.
Do not expose discs to direct sunlight, high humidity, or high temperatures for extended
periods. Long exposure to high temperatures can warp the disc.
Do not stick paper or write anything with a ballpoint pen on the label side of the disc.
Set the Function Selector (3) to the CD Position.
Open the disc compartment by pressing the CD OPEN/CLOSE (6).
When the door has opened, remove a disc from its case and place it carefully in the
compartment with the label side facing front. Locate 3" discs, on the central spindle in the
compartment.
Close the door by pressing on the right side of CD door.
playback.
Adjust the VOLUME control to your desired listening level.
To stop playback temporarily, press the PLAY/PAUSE (II ) button (16) once. The Play
indicator will flash on the display. Press the PLAY/PAUSE (II ) button again to resume
playback.
To stop playback, press the STOP (2) button once.
To switch OFF the unit select OFF with the Function Selector (3).
Wait until the disc is fully stopped before opening the CD compartment.
This unit can play 3" (8cm) single CDs without an adaptor.
Press the SKIP DN (13) button once to go back to the beginning of the current track.
Press the SKIP DN button repeatedly to go back to previous tracks.
Press the SKIP UP (12) button repeatedly to go to next tracks.

Publicidad

loading