Publicidad
541W Monterey 4-Drawer Chest — Parts List
(cont.)
U — #6 x 5/8" Undercut
W — #8 x 1" Machine
Screw — Qty. 16
Screw — Qty. 8
V — Knob — Qty. 8
T — Drawer Slide Set — Qty. 4 Sets
X — Tipping Restraint
*Pre-installed at factory.
Kit — Qty. 1
SPECIAL INSTRUCTIONS
If the top or a panel should become cupped, do not be alarmed. The panel was flat when it
was manufactured. It is a natural characteristic of wood in an unfinished state to cup
from uneven moisture conditions. The Figure at the right shows an exaggerated
view of what could happen. This only means that the convex side has absorbed
moisture, or the concave side has dried out.
Usually a cupped panel will equalize and straighten out if both sides are exposed to similar
conditions for a day or so.
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED:
Phillips Head Screwdriver, Mallet or Padded Hammer, Wood Glue, Tape Measure
IMPORTANT:
We recommend finishing the unit
before final assembly. Before
finishing, read the
enclosed Finishing Hints sheet.
To test for desired color apply stain to
the back of Base (C). See Figure 3.
FIG. 1
1. Lay out the wood parts in their approximate
location to aid in the identification and assembly.
541W – Page 3
Publicidad
