Publicidad
P
x 22
Q
x 4
P
P
FIG. 6A
P
P
P
P
Q
Q
FIG. 6B
Q
Q
6. With the unit laying face down on a protective surface, measure from top left to bottom right
(
) and from bottom left to top right (
). Measurements should be equal.
If the line
is longer, tap bottom of Left Side Assembly (A) until measurements are
equal. If line
is longer, tap bottom of Right Side Assembly (D). See FIGURE 6A.
Place the two Backs (F) onto the unit so that tops of the backs are 1/8" below the top edge
and equal distance from the two side panel edges. Also, make sure the backs are properly
situated so that the edges with no predrilled holes are in the center. Use Screw (P) in the
pre-drilled holes to secure the Backs to the unit. Hammer Tack Glides (Q) into bottom
corners of the unit. See FIGURE 6B.
Page 6 – 541W
Publicidad
