Publicidad
M
x 4
FIG. 2
2. Glue two Wood Dowels (M) in both the Left Side Assembly (A) and Right Side Assembly (D).
N
x 2
O
x 2
Flush to Bottom edge
(not cleat)
FIG. 3
3. Attach Sleepers (B) to Left Side Assembly (A) gluing Wood Dowels (M) and securing with
Screws (N) as shown in FIGURE 3. Make sure the edge of the Sleepers (B) stay straight and
flush to the edge of the Left Side Assembly (A).
Position the Base (C) so that the arch is down and the radius edge is up and out from the
unit. The bottom edge of the Base (C) needs to be flush with the bottom edge of the Left Side
Assembly (A). Use two Screws (O) through the cleat to secure the Base (C) in place.
Page 4 – 541W
M
M
M
O
O
BOTTOM
Stain Test Area
N
Flush with Back Edge
M
N
Flush with
Top Edge
TOP
BACK
Publicidad
