Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE*: The battery and charger are sold separately on some models of the Jacto
PJB-U. Check this information on the equipment packaging.
8.2. Assembling the lance to the trigger valve
Fit the lance into the trigger valve and thread enough so that there is no leakage,
as shown in the image below:
WARNING!
Do not overtighten the screw cap.
8.3. Assembling the hose to the sprayer
• Fit the hose through the S-20 nut, attach it to the connector and thread it.
• Plug the connector into the quick coupler and press until it clicks.
9. Operating Instructions
The following steps describe how to safely use the sprayer.
9.1. Choosing nozzle type
Three nozzles are supplied with the equipment. Each one is designed for a specific
use, according with the user need.
Pest Control nozzles:
• Blue adjustable cone nozzle - It allows the adjustment of the spray to fine
drops in the shape of a cone pattern and to a jet stream from short to long
distances (about 6 meters).
• JEF 8002 yellow nozzle - A uniform flat fan nozzle with good application
range with an 80 ° opening angle, fine droplets for optimum coverage and a
flow rate of 0.8 L / min at 45 psi - ideal for perimeter and full area applications.
Disinfection nozzle:
• JEF 8001 orange nozzle - A uniform flat fan nozzle with good application
range with an 80 ° opening angle, very fine droplets for optimal coverage and
flow rate of 0.4 L / min at 45 psi - ideal for indoor applications that require low
volume with excellent distribution.
8/51
9.2. Pressure, flow rate and autonomy of each nozzle
type
Nozzle
Level
Pressure (psi)
Min.
01
Med.
(ORANGE)
Max.
Min.
02
Med.
(YELLOW)
Max.
NOTE*: The values above may vary as to the wear, clogging and variation of the
nozzles, the density and viscosity of the liquid to be applied, the temperature and
relative humidity of the environment, the altitude and consequent atmospheric
pressure of the site, the height of the lance spraying, etc.
NOTE**: The minimum working nozzle pressure should always be observed, so
we do not recommend spraying at pressures below 15 psi for fan nozzles and
below 45 to 60 psi for conical nozzles depending on the model. In addition, we
do not recommend using ISO standard nozzles of brown color (05 gal/min at 3
bar pressure).
9.3. Calibration of battery powered knapsack sprayer
PROCEDURE
1.
USING CALIBRATOR BOTTLE (OPTIONAL)
2.
Hold the lance at the working height and spray to measure the applica-
tion band width.
3.
Based on the band width, calculate the total walking distance required to
spray the desired area. Use the chart as shown next.
Band width
0.5
(m)
Distance to
50.5
walk (m)
• Remove the cap, nozzle and filter.
• Mount the calibrator cover to the lance.
• Reinstall the filter, nozzle and cap.
• Screw the calibrator onto the cover.
Attach the calibrator bottle to the lance as shown:
Flow rate
Autonomy
(L/min)
(h)
30
0,38
13,0
46
0,44
8,9
61
0,50
5,6
15
0,58
14,6
27
0,72
8,5
39
0,84
5,6
Band
width
0.7
1.0
1.2
1.5
35.7
25.0
20.8
16.7
Lance
Cover
Filter
Nozzle
Nozzle cap
Calibrator
bottle
Publicidad
