Stalgast KG-1 Manual página 41

• The temperature of rooms of cylinder installation shall not exceed 35
with adjustable feet as shown in Fig. 14 (adjustment range - from -20 to 40 mm).
a. In the case of appliances connected to the LPG cylinder:
• Cylinders shall be located at least 1.5 m from heat-radiating devices (heaters, furnaces, etc.), except for
those with cylinder cabinets.
• Attention: If the appliance has a gas cylinder compartment, this compartment should be designed as to
contain only one gas cylinder having a maximum capacity of 20 kg.
• In this case (gas appliance with the cylinder placed in the cabinet) the total heat load of the appliance
should not exceed 12 kW.
• Do not place cylinders in the vicinity of any other sparking appliances.
• Place the cylinders upright and protect them against impact, overturning or accidental moving.
• The liquid gas stove should be connected to the hose (LPG hose bearing „B" safety mark) by means of a
seamless steel pipe at least 50 cm long.
• The hose must be protected with wire ties at both ends to prevent it from sliding. The length of the hose
must not be less than 1.2 m and not higher than 3.0 m.
• LPG cylinder should be equipped with a gas pressure regulator. The pressure at the outlet from the
pressure regulator should correspond to the pressure on the nameplate
b. In the case of appliances connected to a natural gas installation:
• Natural-gas stoves (2E; 2H; 2LW; 2L) should be connected to the gas system inside the building as xed
connection or with exible metal hoses bearing the valid safety mark. The stove has a gas connection
with an R ½" thread (Fig.15 item 1).
1
2
Gas stool cooker
c. Adaptation of the appliance to another type of gas should be performed by an authorized t-
ter. It involves the following:
• Nozzle replacement in gas burners - nozzle diameters for the respective gas are given in the tables un-
der the heading „Characteristics of burners"
• The aluminium sleeve in the burner body is xed accordingly - unscrew the screw xing the burner
sleeve, slide it out or slide it into the body to the position consistent with the table „Setting the burner
shutter".
• Adjust the minimum ow in the control cock - by screwing or unscrewing the screw next to the pilot
valve mandrel, adjust the gas ow so that the ame does not go out when the knob is turned from full
ow to minimum ow setting.
• Adjusting the gas ow at the pilot burner:
Figure 14. Levelling the unit
Freestanding gas cooker
Figure 15. Rear view to the unit.
- 41 -
o
C. The kitchen should be leveled
1. Gas connection
2. Nameplate