Tennant V-WD-16P Manual Del Operario página 13

9. Slide pedal between two mounting arms on back of
machine. Align and insert clevis pin through arms
and slot in pedal, secure with cotter pin (Figure 5).
FIG. 5
10. Attach squeegee assembly to bracket. Use (2)
thumb screws to secure (Figure 6).
FIG. 6
11. Connect 117 cm (46 in) vacuum hose to squeegee
assembly and to neck on machine lid (Figure 7).
FIG. 7
V- -WD- -16P (04- -10)
Home Find... Go To..
MACHINE SETUP
1. Connect 15m (50 ft) power cord to machine pigtail
cord.
2. Plug power cord into a grounded outlet (Figure 8).
Grounded
3 Hole Outlet
Ground Pin
FIG. 8
FOR SAFETY: Do not operate machine with the use
of additional extension cords. Only use
manufacturer's extension cord equipped with
machine which has proper capacity and is
grounded.
WET VACUUMING
1. Open machine cover and remove vacuum bag from
recovery tank (Figure 9).
FIG. 9
2. Make sure automatic float shut-off screen is in
place (Figure 10).
FIG. 10
ATTENTION: To prevent vacuum motor damage,
automatic float shut-off screen must be in place.
OPERATION
EN
13