Reverse Door Swing (Optional) - Impecca RA-2107 Manual De Usuario

WHEN MOVING YOUR REFRIGERATOR:
Your refrigerator is heavy. When moving the refrigerator for
cleaning or service, be sure to cover the floor with cardboard
or hardboard to avoid floor damage. Always pull the refrigera-
tor straight out when moving it. Do not wiggle or "walk" the re-
frigerator when trying to move it, as floor damage could occur.
CLEAN BEFORE USING
After you remove all of the packaging materials, clean the in-
side of the refrigerator before using it. See the cleaning instruc-
tions in "Refrigerator Care."
IMPORTANT INFORMATION TO KNOW ABOUT GLASS
SHELVES AND COVERS:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to sud-
den temperature changes or impact, such as bumping. Tem-
pered glass is designed to shatter into many small, pebble-size
pieces. This is normal. Glass shelves and covers are heavy. Use
both hands when removing them to avoid dropping.

REVERSE DOOR SWING (OPTIONAL)

If you want to reverse the door swing so that the doors open
from the opposite side see the following instructions.
IMPORTANT: The graphics referenced in the following instruc-
tions are included later in this section. See "Reverse Door
Swing" graphic.
REMOVE THE DOORS
I WARNING
EXCESSIVE WEIGHT HAZARD
USE TWO OR MORE PEOPLE TO MOVE AND INSTALL REFRIG-
ERATOR.
FAILURE TO DO SO CAN RESULT IN BACK OR OTHER INJURY.
1. Unplug refrigerator or disconnect power.
2. Remove all food, shelves, drawers, trays and bins from the
interior refrigerator cabinet and the door.
3. While someone holds the doors, unscrew the bolts and
remove the center hinge (1).
4. Lower the refrigerator door from the top hinge (2).
5. Lift the freezer door from the bottom hinge (3).
6. Remove the bolts from the top hinge and remove top
hinge (5).
7. Using two or more people, tilt the refrigerator toward the
back at a 45° angle to access and remove the leveling foot (7
& 8).
8. Remove the bottom door hinge and leveling foot (9).
NOTE: The leveling foot on the hinge side must be moved to
the opposite side with the door hinge.
–6–