Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
1.
To set the code on receiver unit, slide dip switches
to the same positions as set on the remote. (Figure 1)
NOTE: Factory setting is all up. Do not use this
position.
WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
(Figure 2)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
CAUTION: INCORRECT WIRE CONNECTION WILL
DAMAGE THIS RECEIVER.
2.
Connect green wires from hanger bracket and
downrod to bare (ground) wire using wire connector.
Connect black wire from receiver unit marked
"AC IN L" to black supply wire using wire connector.
Connect white wire from receiver unit marked
"AC IN N" to white supply wire using wire connector.
Connect white wire from receiver unit marked
"TO MOTOR N" to white wire from fan using wire
connector supplied with receiver unit. Connect black
wire from receiver unit marked "TO MOTOR L" to
black wire from fan using wire connector supplied with
receiver unit. Lastly, connect blue wire from receiver
unit to the blue fan light wire using wire connector
supplied with receiver unit. (Figure 3)
NOTE: If you feel that you do not have enough
electrical wiring knowledge or experience, have your
fan installed by a licensed electrician.
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors except for the ground wire. Do not operate
fan until the blades are in place. Noise and motor
damage could result.
3.
After connections have been made, turn leads
upward and carefully push leads into the outlet box,
with the white and green leads to one side of the box
and the black leads to the other side. (Figure 4)
How to Wire Your Ceiling Fan
Blue to Light
Black to Motor
White to Motor
Wire
Connectors
Green Wire
from Supply
(Ground)
Green Wire
from Hanger
Bracket (Ground)
Green Wire
from Hanger
Ball (Ground)
10
Receiver
ON
DIP
1
2
3
Dip Switch
Figure 1
Main Fuse Box
Figure 2
Figure 3
HARDWARE USED:
x 6
White Wire
from Supply
White Wire
from Receiver
Receiver
Figure 4
4
5
all
Listed
Outlet Box
Household
Supply
Black Wire
from Supply
Black Wire
from Receiver
Publicidad
