Publicidad
Idiomas disponibles
Idiomas disponibles
How to Assemble Your Light Kit or Cap (Continued)
6. For use with light kit
Remove the three screws in the light plate
assembly and retain the screws for Step 8. (Figure 6)
NOTE: If you have installed your fan with the steel
cap, skip Steps 6, 7, 8 and 9.
7.
Connect the 2 single-pin connectors from the LED
assembly to the 2 single-pin connectors from light
plate assembly. (Figure 7)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
8.
Assemble the LED assembly to the light plate
assembly using the removed screws in from Step 6
and secure all three screws. (Figure 8)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
9.
Secure the light shade to switch housing assembly
by twisting in a clockwise direction.
Do not over-tighten. (Figure 9)
10. For use with steel cap
Assemble the light kit wire cover to the light plate
asseumbly using the two key slots and tighten with
the supplied screw. (Figure 10)
Light Plate
Assembly
Light Plate
Assembly
Switch Housing
Assembly
13
Light Plate
Assembly
Figure 6
LED Assembly
Figure 7
LED Assembly
Figure 8
Light Shade
Figure 9
Light Plate
Assembly
Light Kit
Wire Cover
Figure 10
Publicidad
