Publicidad
Idiomas disponibles
Idiomas disponibles
English
LUBRICATION
This tool is fitted with blades which can
operate without lubricated air. However,
a small amount of oil allows the tool to
provide full power and lengthens its life.
The use of dry air with no trace of oil may
reduce the life of blades.
MAINTENANCE INSTRUCTIONS
The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of the
manufacturer's liability.
To obtain maximum efficiency from the
pneumatic tool, preserve its features
and avoid repeated repairs, a routine
inspection and repair programme
are recommended at least every 500
hours, the intervals between the various
inspections depending on the amount of
exertion on the power tool.
When disposing of components,
lubricants, etc... ensure that the relevant
safety procedures are carried out.
03/2013
DISASSEMBLy AND REASSEMBLy
INSTRUCTIONS
See page 4.
Disconnect the machine from the
compressed air supply.
Remove all accessories.
Be careful with the direction to fit the locknut
(605.62), with the machined side resting on the
bearing (758.67).
When assembling the turbine, frictions may
occur; they will disappear after full tightening of
the valve body (315.35).
Be careful with the direction for
assembling the blade wheels
(see figure 3).
Lubrication
Never lubricate the grinder since its bearings are
life lubricated.
Maintenance
Clean the filter (PO56381).
2
3
A
B
9 / 36
2050478213_06
Indicates direction of dismantling.
A : Rotated bladed
A
wheel.
B : Fixed bladed
wheel.
Series: C
Publicidad
