Publicidad
Idiomas disponibles
Idiomas disponibles
Enclosure Configuration
Combining (Baying) Enclosures
WARNING: Combining enclosures is not a substitute for stabilizing the enclosures. Each enclosure in a bay of combined enclosures requires
the same stabilizing measures as a standalone enclosure.
1
Arrange the enclosures in the correct position for baying.
2
Each enclosure includes 4 baying brackets
the adjoining enclosure. The baying connection points already contain screws. Remove the screw
from each baying connection point in the adjoining enclosure.
3
Loosen the screw in each baying bracket and turn each bracket 90 degrees toward the adjoining
enclosure, aligning each bracket with the corresponding baying connection point on the adjoining
enclosure.
4
Connect each bracket to the adjoining enclosure using the screws you removed in step 2, but do
not tighten the screws completely. Adjust the position of the enclosures as needed. If you want the
centers of the enclosures to be 24 inches (61 cm) apart/29.9 inches (76 cm) for the SR42UBWD,
use the outside hole of the bracket
apart/75 cm (29.5 inches) for the SR42UBWD, use the middle hole of the bracket
connecting all brackets and confirming that the enclosures do not need further adjustment, tighten
all screws.
Note: You may wish to remove the doors from the enclosures before combining them. Reinstalling
the doors afterward is optional. Remove the interior side panels before baying enclosures if you
wish to enable access between enclosures.
29
Equipment Installation
28
WARNING: Do not install equipment until you have stabilized the enclosure. Install heavier equipment first and install it toward the bottom of
the enclosure. Install equipment starting from the bottom of the enclosure and proceeding toward the top of the enclosure - never the
reverse. If using sliding equipment rails, be careful when extending the rails. Do not extend more than one set of sliding equipment rails at
one time. Avoid extending sliding equipment rails near the top of the enclosure.
27
Note: The square holes at the middle of each rack unit are numbered and also include a small notch to aid identification. A single rack unit includes the
space occupied by the numbered hole and the holes directly above and below.
26
25
24
24
23
22
A
that correspond to baying connection points
C
. If you want the centers to be 60 cm (23.6 inches)
1 Rack Unit
1
B
on
2
3
D
. After
4
11
B
A
90°
D
C
29
28
27
26
25
2
24
24
23
22
Publicidad
