Tripp-Lite SmartRack AG-039A Manual Del Propietário página 7

Enclosure Configuration
Adding or Removing Front and Rear Doors
WARNING: Do not attempt to add or remove doors without assistance.
Removing Door
1 Disconnect the door's ground wire.
2 Open the door until it is perpendicular (90 degrees) to the front of the enclosure.
3 Lift the door from the hinges and remove it from the enclosure.
To Reinstall Door, Reverse Steps 1-3
(Optional) If the enclosure is joined to another enclosure, turn the door back toward the enclosure as
you lift it from the hinges.
Reversing Front Door
WARNING: Do not attempt to reverse the front door without assistance.
1 Remove the screw connecting the ground wire to the inside of the door.
2 Remove the 2 screws connecting the door handle to the door. Remove the door handle.
1
2
3
1
2
7
90°