Descargar Imprimir esta página

Stanley SW21 Instrucciones Originales página 22

Publicidad

Idiomas disponibles

Idiomas disponibles

22 • ENGLISH
Warning! Safety signs. Comply with the instructions
provided by the safety signs ted to the appliance. Check
that they are present and legible; otherwise, replacements
in the original positions.
TECHNICAL INFORMATION
ENVISAGED USE
This appliance has been designed for individual use for
the cleaning of vehicles, machines, boats, masonry, etc, to
remove stubborn dirt using clean water and biodegradable
chemical detergents.
Vehicle engines may be washed only if the dirty water is
disposed of as per regulations in force.
f Intake water temperature: See data plate on
the appliance.
f Intake water pressure: min. 0.1 MPa - max. 1 MPa.
f Operating ambient temperature: Above 0 °C.
The appliance is compliant with the IEC 60335-1 and IEC
60335-2-79 standards.
OPERATOR
The symbol illustrated in Fig. A identifies the appliance's
intended operator (professional or non-professional).
MAIN COMPONENTS (Fig. A)
1. Lance
2. Gun with safety catch
3. High pressure hose
4. Nozzle cleaning tool
5. Rotating nozzle kit
6. Nozzle
7. Adapter
8. Water filter
9. Detergent kit
10. Screws
11. Electric cable with plug
12. Wheels
13. Hose reel
14. Handle
15. Lever
16. Brackets
Starter device (19)
The starter device prevents accidental use of the appliance.
Caution! Safety devices:
Do not tamper with or adjust the safety valve setting.
f Safety valve and/or pressure limiting valve.
The safety valve is also a pressure limiting valve.
When the gun trigger is released, the valve opens and
the water recirculates through the pump inlet or is
discharged onto the ground.
f Thermostat valve (where fitted)
If the water temperature exceeds the temperature
set by the manufacturer, the thermostat valve
discharges the hot water and draws in an amount of
cold water equal to the amount of water discharged,
until the correct temperature is restored.
f Safety catch (21): prevents accidental spraying of water.
f Overload cutout: stops the appliance in case
of overload.
INSTALLATION (Fig. B)
Assembly
Warning! All installation and assembly operations must
be performed with the appliance disconnected from the
mains power supply.
The assembly sequence is illustrated in Fig. B.
Fitting the rotating nozzle
The rotating nozzle kit delivers greater washing power.
Use of the rotating nozzle may cause a reduction in
pressure of 25% compared to the pressure obtained with the
adjustable nozzle. However, the rotating nozzle kit delivers
greater washing power due to the rotation of the water jet.
Electrical connection
Warning! Check that the electrical supply voltage and
frequency (V/Hz) correspond to those on the appliance
data plate (Fig. B8).
Use of extension cables: Use cables and plugs with
"IPX5" protection level. The cross-section of the extension
cable should be pro- portionate to its length; the longer it
is, the greater its cross-section should be.
Water supply connection
Caution! Only clean or filtered water should be used for
intake. The delivery of the water intake tap should be equal
to that of pump capacity.
Place the appliance as close to the water supply system
as possible.
Connection points:
Water outlet (OUTLET)
Water inlet with filter (INLET)
Connection to the mains water supply
The appliance may only be connected directly to the mains
drinking water supply if the supply hose is fitted with a
backflow preventer valve as per current regulations in
force. Make sure that the hose is at least Ø 13 mm, that it
is reinforced and that it is not more than 25 m long.

Publicidad

loading