BH FITNESS YC1000 Manual Del Usuario página 6

FITTING THE BATTERIES.-
This monitor
ALKALINE BATTERIES. To fit the
batteries, remove the rear cover on
the monitor, Fig. 1, and carefully insert
the two "R-6" type batteries into the
battery compartment (A) making sure
that the battery's polarity is correct
(matching the battery's «+» terminal
with the «+» sign inside the battery
compartment, and the «-» terminal
with the «-» sign). Close the cover, as
shown in Fig. 1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important. Discarded batteries must
be deposited in special containers,
Fig. 2.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit provides
simultaneous read-outs
distance, exercise time, calories burnt
and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes.
Pressing the MODE key for more than
two seconds will reset all of the
values. Pressing RESET will delete
value set.
uses two 1.5
of speed,
English
A. SCAN FUNCTION.-
volt In SCAN
continuously scans and displays all of
the functions during exercise. The
function being displayed will flash on
and off.
To select the SCAN function:
1. The monitor starts in SCAN mode
as soon as exercise begins or if any
key is pressed, the main screen will
display TIME, SPEED, DISTANCE,
ODO,
values every 6
2. Press the MODE key and this will
cancel the SCAN function.
B. TIME FUNCTION.-
This function counts up or down in
steps of one minute, up to a maximum
of 99:00 minutes.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small TIME window flashing.
3. Press the SET key to select the
time.
4. Begin the exercise and the time
value will begin the countdown, when
it reaches zero it will beep for 8
seconds,
selected time has elapsed, the time
value will then start counting upward.
C. DISTANCE FUNCTION.-
This function counts up or down in
steps of 1 km/ml, up to a maximum of
999 km/ml.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small DISTANCE window flashing.
6
mode the
CALORIES, PULSE
seconds.
advising you
computer
RATE
that the