EINHELL TC-PL 900 Manual De Instrucciones Original página 18

better control over the tool in unexpected
situations.
•
Wear suitable clothes. Never wear loose
fitting clothes or jewelry. Keep hair, clothes
and gloves away from moving parts. Loose
clothing, dangling jewelry and long hair can
be caught by moving parts.
•
If dust extraction and dust collection devices
can be mounted, ensure that these are con-
nected and are properly used. The use of a
dust extraction system can reduce the danger
posed by dust.
4. Using the treatment of electric tools
•
Do not overload your tool. Only use suitable
electric tools to perform your work. Using the
right electric tool allows you to work better
and safer within the tool's quoted capacity
range.
•
Do not use an electric tool whose switch is
defective. An electric tool that no longer can
be switched on or off is dangerous and must
be repaired.
•
Pull the plug out of the socket and/or remove
the battery before making any adjustments to
the tool, changing accessories or put the tool
down. This precaution eliminates the possibi-
lity of inadvertently starting the tool.
•
When not in use, store electric tools out of the
reach of children. Do not allow those persons
to use this tool who are unfamiliar with it or
who have not read these instructions. Electric
tools are dangerous when they are used by
inexperienced persons.
•
Take good care of your tool. Check that mo-
ving parts properly function and do not jam,
that parts are not broken off or damaged in
any way and that the tool can be used to its
full capacity. Have damaged parts repaired
prior to using the tool. The cause of many
accidents can be traced back to poorly main-
tained electric tools.
•
Keep your blades sharp and clean. Properly
maintained blades with sharp edges jam less
frequently and are easier to use.
•
Make sure to use electric tools, accessories,
attachments, etc. in accordance with these
instructions. Take the conditions in your work
area and the job in hand into account.
•
Using electric tools for applications other
than those intended can lead to dangerous
situations.
5. Service
Anl_SA_TC_PL_900_SPK8.indb 18 Anl_SA_TC_PL_900_SPK8.indb 18
GB
•
Have your tool repaired only by authorized
specialists using original replacement parts.
This will ensure that your tool remains safe
to use.
Special safety instructions
Always secure the workpiece if possible: Use
clamps or a vise to hold the workpiece securely.
This is far safer than holding it in your hand and
also means that you have both hands free to ope-
rate the electric tool.
•
Ensure that there are no foreign objects
adhering to the workpiece in order to avoid
damaging the electric hand plane.
•
Hold the tool by its handle using both hands
and place the front base plate of the plane on
the workpiece. The base plates must evenly
rest on the workpiece during the planing
process.
•
Allow the tool to reach its maximum operating
speed before you start to plane.
•
Let the plane run to a complete stop before
you set the tool down. An exposed knife block
can catch the surface, lead to loss of control
and, ultimately, serious injury.
•
Set the planing depth to 0 mm when you have
finished working.
•
Replace used planing knives with a set of
new knives when worn down.
•
Some types of planing knives have two bla-
des. When one blade has become blunt, the
planing knife can be turned over.
•
Blunt planing knives cannot be resharpened.
•
Always ensure that you replace both knives at
the same time.
•
Only the original, manufacturer-approved
knife block may be used for this electric hand
plane.
•
Always use only clean and sharp planing kni-
ves to ensure professional, safe results.
Do not lose these safety regulations.
- 18 -
10.10.2017 13:49:05 10.10.2017 13:49:05